Contents

Deflating it completely can sometimes cause the leather or synthetic panels to separate and ruin the ball. It is not something that will definitely happen but something to look out for. Just make sure you deflate it slowly and keep an eye on the ball. There is no need to worry about this for all rubber balls.

The easiest way to deflate a basketball is with an inflation needle (also called a pump needle) that you would normally use to inflate the basketball. … For a large amount of air, or if deflating the ball completely, it would be a better idea to remove the needle from the pump.

## How much can you deflate a basketball?

And do not fill your basketball when it is cold, or it could cause the bladder to burst. When deflating your ball for storing, it’s recommended that 3-4 pounds be left in the ball to keep its cover from getting damaged.

## Can you over pump a basketball?

An overinflated ball can be bad as well. It will bounce too high when you dribble, bank too hard off the backboard and bounce passes will go farther than you intend them to go. This is why it is important to have your basketball inflated to the specified pressure or at least near the specified pressure.

## Can a basketball pop from too much air?

While you likely learned in Physics 101 that too much air pressure could cause a ball to burst, it’s still fascinating to watch one split at the seams. And it’s a good thing he shows it in slow motion—the initial pop happens too quickly to catch with the naked eye.

## How pumped should a basketball be?

NBA rules dictate that basketballs should be inflated to between 7.5 and 8.5 pounds per square inch. If the basketball is inflated below this level, it won’t bounce correctly. If it is inflated above this level, the basketball could be damaged or burst.

## Can you take air out of a ball?

If you only want a little air to come out of the ball, simply squeeze the ball with your hands until the desired amount of air remains in the ball. Pull the needle slowly out of the ball. When you remove the needle, the ball will stop deflating, but be careful not to pull the valve out of the ball as well.

## Can you pump a basketball without a needle?

Method 1: Use a Can of Compressed Air

Best to use for: If you are without a needle and pump, a can of compressed air is probably the quickest and easiest way to fill up your ball. It offers you something very similar to the needle, so getting the air in the ball will be simple.

## How do I reduce air in my ball?

Lubricate the valve with some water or saliva. Insert the lubricated needle slowly and at a right angle to the ball. When you hear the hissing sound of air being released from the ball, hold the needle in that position. Hold the ball tightly to squeeze out the air and prevent the needle from snapping.

IT\'S FUNNING:  Quick Answer: Who was the best NBA team in 2010?

## How do you deflate a Never Flat basketball?

Look for a round, black rubber cap on the basketball. Push the cap up enough that you can bend it aside, exposing the hole underneath. This will release air and break the one-year warranty on Neverflat basketballs.

Although rare, a basketball can explode if it is stored at a temperature that is too cold or if it is over-inflated to a considerable level beyond the standard PSI. An exploding basketball can be very dangerous and can cause harm to those nearby.

## Why is my basketball not bouncy?

If the basketball bounces up close to the chest, it means it has too much air. If it does not bounce up to the waist, it means there is not enough air. … Drop the ball from the 72 inch mark and the top of the basketball should be between the 49 and 54 inch mark you made. If it bounces higher than 54, it has too much air.

## How do you tell if a basketball is properly inflated?

If you don’t have a pump with a air pressure gauge, you can reasonably judge whether the basketball is properly inflated by this method: Hold the ball in front of your face and drop it… if it bounces up to your belt buckle, then it is properly inflated.

## How much PSI does a basketball explode?

The amount of air is measured in pounds per square inch, which may be abbreviated as “lbs/in²” or simply “psi.” Your basketball will likely direct you to inflate the ball somewhere between 7 to 9 pounds per square inch.

IT\'S FUNNING:  Which college has the first basketball team?

## How hard should a basketball feel?

NBA recommends that the air pressure in a basketball must be between 7.5 and 8.5psi. You can use this standard measurement as a guide to get the required air pressure for your basketball. A quick way to check if your ball has the proper air pressure is by taking this simple test.

## What happens when you inflate a ball too much?

It’s no surprise that a basketball would explode if you pumped it with a ridiculous amount of air but it’s really cool to see it unravel in super slow motion. The ball basically disintegrates and you can see the limp leftovers tear apart from each other as the orange sphere separates from having too much air inside.